Rockwell Automation 2711-M3A18L1_M3A19L1 PanelView 300 Micro Terminals Installation Instructions - Manual (Page 10)

10 PanelView 300 Micro Terminal
41061-156-01(A)
Connecting DC Power
The PV300 Micro terminal connects to a 24V dc power source. The table below
shows the electrical ratings for the DC versions of the terminals. Electronic
circuitry and an internal fuse protect the terminals from reverse polarity and
over-voltage conditions.
PV300 Micro terminal is designed for safe use when installed in a suitably rated
NEMA Type 12, 13, 4X (indoor use only), IP54 or IP65 enclosure.
The input power terminal block on the PanelView 300 Micro is removable and
supports the following wiring types.
Terminal Type Supply Voltage Power Consumption
PV300 Micro 11 to 30V dc
(24V dc nominal) 2.5 Watts maximum
(0.105 Amps @24V dc)
!
ATTENTION
• Do not connect the PanelView terminal to an AC power
source. Connecting to an AC power source will damage the
terminal.
• Use only a Safety Extra Low-Voltage (SELV) power supply
with an output rated between 11 - 30V dc as a power source
for the PanelView 300 Micro. A SELV power supply does
not exceed 42.4V dc.
Wire Type Wire Size (2-wire maximum per terminal)
Solid #16 to #22 AWG
Stranded #18 to #22 AWG