Rockwell Automation 1792D-4BV4D ArmorBlock MaXum 4 Input/4 Output Module with 8 Connectors, Series B I.I. - Manual (Page 4)

4 ArmorBlock MaXum 4 Input / 4 Output Module with 8 Connectors, Series B
Publication 1792D-IN050A-EN-P - February 2001
The module is equipped with AutoBaud detect. AutoBaud lets the
module read the settings already in use on your DeviceNet network
and automatically adjusts to follow those settings.
Install the Module
This module mounts to the following cable bases:
•
1792D-CBFM for KwikLink™ flat media installation
•
1792D-CB12 for 12mm drop cable installation
•
1792D-CB18P for round media DeviceNet and output power
•
or other optional cable base assembly.
To install the module:
1. Position the module over the mounted cable base. Align the
three captive screws in the module with the accepting
receptacles in the base.
2. Tighten the screws with a torque of 8 inch-pounds to secure
the module to the base.
IMPORTANT
The cable base should already be installed. See
publication 1792D-IN009B-EN-P to install the cable
base.
IMPORTANT
Proper alignment of the screws is necessary to
complete the connections between the module
contacts and the cable contacts.