Rockwell Automation 1769-IT6 Compact I/O Thermocouple/mV Input Module - Manual (Page 7)

Compact I/O Thermocouple/mV Input Module 7
Publication 1769-IN026C-EN-P - February 2010
Install the Thermocouple/mV Input Module
The module can be attached to the controller or an adjacent I/O module before or after
mounting. For mounting instructions, see
Mount the Module to a Panel on page 9 , or Mount
the Module to a DIN Rail on page 10 . To work with a system that is already mounted, see
Replace a Single Module within a System on page 10 .
This procedure explains how to assemble the Compact I/O system.
1. Disconnect power.
2. Check that the bus lever of the module to be installed is in the unlocked (fully right)
position.
3. Use the upper and lower tongue-and-groove slots (1) to secure the modules together
(or to a controller).
4. Move the module back along the tongue-and-groove slots until the bus connectors (2)
line up with each other.
5. Use your fingers or a small screwdriver to push the bus lever back slightly to clear the
positioning tab (3).
IMPORTANT
To reduce the effects of electrical noise, install the 1769-IT6 module at least two slots
away from Compact I/O 120/240V AC power supplies.
2
1
1
3
4
5
6