Rockwell Automation 1779-KP5_KP5R ORD.1779-5.3 - Manual (Page 67)

Using 6200 Series Software
Version 2.1 and Earlier
Appendix B
BĆ2
The following table tells you what information you must enter at each
prompt:
At This Prompt: You:
Read/Write Toggle between READ for a read command and WRITE for a
write command.
PLCĆ5 Data Table Address Enter the local data table address where data starts for the
WRITE command or data will be stored for the READ
command.
Size in Elements Enter the message size in elements.
Local/Remote Select REMOTE (through the 1779ĆKP5).
Remote Station Enter the destination NODE number. If the USER number is
not the default (01), then you will need to manually enter it in
the control file as described later in this appendix.
Link ID Enter the destination LINK value.
Remote Link Type Select DATA HIGHWAY for Data Highway II or Data Highway
Plus.
Local Node Address Enter the address of the 1779ĆKP5.
Processor Type Select the destination processor type (toggle between PLCĆ2,
PLCĆ3, and PLCĆ5).
Destination Data Table
Address
Enter the destination processor's data table address.
If the USER number you use is not the default (01), you need to manually
enter the USER number in the message control file. The following
section provides a procedure for entering a USER number into the control
file.
Important: When you manually enter a USER number, the remote station
number appears to be incorrectly displayed due to how the 1784-T50
interprets the USER number.