Rockwell Automation 1779-KP5_KP5R ORD.1779-5.3 - Manual (Page 30)

Installing the 1779ĆKP5 Module
Chapter 3
3Ć17
To power up the 1779-KP5, use the following procedure:
1. Set the AC POWER switch on the front panel of the module to OFF.
AC POWER ON
ON
AC POWER
OFF
FUSE
SLOW BLOW
2A. 250V
DATA
HWY II
PORT
1779-KP5R DHII/DH+ INTERFACE
115V AC/ 230V AC
INTERNALLY
SWITCH
SELECTABLE
L1
L2/N
GND
16015
DATA
HWY II
PORT
2
1
AC Power
Switch
2. Restore power to the 1779-KP5. Usually, this means you must close
the main disconnect switch on the enclosure containing the
1779-KP5.
3. Set the AC POWER switch to ON.
When you power up the 1779-KP5, all the diagnostic LEDs on the
interface flash briefly as the module executes power-up diagnostics.
The LEDs should then switch to normal operation.
Refer to Chapter 6 for:
A More Complete Description of the LED Indicators
A Description of Troubleshooting Tools You Have Available
Powering Up the 1779ĆKP5
Interface