Rockwell Automation 1771-SDN DeviceNet Scanner Module Installation Instructions User Manual

Devicenet scanner module, Installation instructions, Catalog number 1771-sdn/c contents

Text mode
Original mode

Rockwell Automation 1771-SDN DeviceNet Scanner Module Installation Instructions User Manual | 40 pages

Table of contents

Document Outline

DeviceNet Scanner Module Catalog Number 1771-SDN/C
Contents
Important User Information
Prevent Electrostatic Discharge
Where to Find More Information
Module Compatibility and Maintenance Requirements
Module Enhancements
- Updated DeviceNet Master Library
Other Features
- Change of State
- Cyclic I/O
- Pass-Through
External Module Features
- Series A Channel, Port and Switch Identification
Software and Hardware Requirements
- Software Requirements
- Hardware Requirements
- Perform the ControlFLASH Update
Set the Data Rate Switches for Channels 1 and 2
Set the I/O Chassis Addressing Mode Switches
Set Node Address Switches for Channels 1 and 2
Install Your Module into the Chassis
Connect to the DeviceNet Network
How Your Module Communicates with the PLC-5 Processor
Program Your PLC-5 Processor
- Using BTW to Send Outputs to the Scanner
- Module Command Register
- Use BTR to Upload Input Data from the Scanner
- Module Status Register
- Device Active Table
- Device Failure Table
Configure Your Module for the DeviceNet Network
- Clear the Scanner Module’s Scan List
Use the Explicit Message Program Control Feature
- How the Explicit Message Program Control Feature Works
- How to Format the Explicit Message Transaction Block
- How the Processor and Scanner Module Manage Messages
- Explicit Message Program Control Limitations
- Explicit Messaging Error Codes
Troubleshoot Your Module
- The following information applies when operating this equipment in hazardous locations:
- Informations sur l’utilisation de cet équipement en environnements dangereux :
Specifications
Back Cover