Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual - Manual (Page 99)

Publication 1747-UM655B-EN-P - June 2007
DeviceNet Explicit Messaging 99
Any time the error code is non-zero, the DEM error (ER) bit is set.
CIP Response Error Codes
Numeric Code Name Description
02H Resource unavailable A needed resource was not available
08H Service unsupported Service is not defined or implemented for this class/instance
09H Invalid attribute value Data is invalid for the specified attribute
0BH Already in requested state Object is in the requested state - redundant request
0CH Object state conflict Not allowed with object in present state
0EH Attribute cannot be set Read-only attribute
0FH Privilege violation A permission/privilege check failed
10H Device state conflict Not allowed with device in present state
11H Reply too big Reply larger than buffer allocated when connection was established
13H Too little data Request included insufficient data
14H Attribute not supported Attribute number is incorrect
15H Too much data Request included extra data
16H Object does not exist Class/instance numbers are incorrect
18H No stored attribute data Attribute data was not saved prior to this request
19H Store operation failure Attribute data was not successfully saved
1FH Vendor-specific error Second byte may offer details - refer to vendor documentation
20H Invalid parameter Parameter associated with request is invalid
D0H Reserved and
service-specific errors Used only when none of the standard error codes supplemented by the second byte
accurately describes the problem
FFH