Rockwell Automation 1734-485ASC POINT I/O ASCII User Manual - Manual (Page 38)

Publication 1734-UM009B-EN-P - July 2003
2-12 Configuring Your ASCII Module
Serial Port Transmit to ASCII Device
Max Number of
Transmit Chars 17 Get/Set Maximum number of
characters the
1734-232ASC
module expects to
transmit out its
serial port to the
serial device 1-128 20 chars 14
hex
USINT
Transmit End
Delimiter Mode 18 Get/Set Selects whether or
not the End
delimiter is included
with the received
data 0 = No End Delimiter
1 = Exclude End
Delimiter
2 = Include End
Delimiter
Include 2 USINT
Transmit End
Delimiter Character 19 Get/Set Character which
identifies the end of
the transmit data
string from
DeviceNet to the
ASCII device when
the length is
specified as 0 Any valid standard
ASCII character
(0-127 with 7-bit
data, 0-255 with 8-bit
data)
Carriage
return
D
hex
USINT
Consume on DeviceNet from Master
Consume String
Data Type 20 Get/Set Defines the format
of the data string
received from the
master 0 = Array
1 = Short_String
2 = String
Short_
String
1 USINT
Transmit Swap
Mode 21 Get/Set If enabled, the
position of the bytes
in the serial
messages will be
swapped every 2 or
4 bytes 0 = Disabled
1 = 16-bit Swap
Enabled
2 = 24-bit Swap
Enabled
3 = 32-bit Swap
Enabled
Disabled 0 USINT
Transmit Handshake
Mode 22 Get/Set Selects the source
of the event that
triggers the
transmission of data
over the serial link 0 = Transmit
Handshake
1 = Transmit
Immediate
Transmit
Handshake
0 USINT
Consume Assembly
Size 23 Get Total number of
bytes of I/O data
that are received
from the master.
This should be the
TX size of your
scanner. 4-132 20 bytes of
array data
and 4
header
bytes
24 USINT
Table 2.3 Parameter List
Parameter Parameter
Instance
Access Description Parameter Choices Default
Setting Default
Value
Data Type