Rockwell Automation Allen-Bradley Plot Software User Manual - Manual (Page 36)

PLOTTING 36
PLOTTING The plotting of markers and project information is carried out in the follow-
ing steps:
1. A plot file with the values of the Plotter installed is created and saved to
the hard drive.
2. The plot file (print job) is sent to an output device.
Ensure the plotter plate has been calibrated prior to plotting.
The Output Window
Figure 40 Configuring the Output
The Output window is called up from the Marker Card or Input Screen by
selecting the command "Plot..." from the "File" menu, or by actuating
button in the toolbar.
This window indicates the plotter and port in use. The Project field con-
tains a list of all the documents currently open. The document to be printed
can be determined by clicking on the file name.
The number of copies of a document which will print is selected in the Cop-
ies field by actuating the spin buttons.
Area
Complete document All Marker Cards are plotted.
Current Marker Card Only the current Marker Card is plotted.