Rockwell Automation 700-HX Multifunction Digital Timer - Manual (Page 13)

Publication 700-UM002B-EN-D - June 2010
3-2 Functions
Explanations of Functions Time Range ( timr )
Set the range to be timed in the range 0.000 s… 9,999 h. Use the operation
keys if these settings are required.
Timer Mode ( timm )
Set either the elapsed time (UP) or remaining time (DOWN) mode.
Output Mode ( outm )
Set the output mode. The possible settings are A, A-1, A-2, A-3, B, B-1, D, E,
F, Z and S. (For details on output mode operation, refer to “Timing Charts”
on page 3-11.)
Output Time ( otim )
When using one-shot output, set the output time for one-shot output (0.01…
99.99 s). One-shot output can be used only if the selected output mode is A,
A-1, A-2, B, or B-1. If the output time is set to 0.00,
hold is displayed, and the
output is held.
Input Signal Width ( iflt )
Set the minimum signal input width (20 ms or 1 ms) for signal and reset
inputs. The same setting is used for all external inputs (signal and reset). If
contacts are used for the input signal, set the input signal width to 20 ms.
Processing to eliminate chattering is performed for this setting.Set the key
protect level.
Set Value Upper Limit ( sl-h )
Set the upper limit for the set value when it is set in Run Mode. The limit can
be set to between 1 and 9999. This setting does not apply to the ON duty in Z
mode.
Output ON Count Alarm Set Value ( on-a )
Set the alarm value for the output ON count.The limit can be set to between 0
x 1000 times and 9999 x 1000 times. (The rightmost three digits will not be
displayed.) If the total ON count of the output exceeds the alarm set value, e3
will be displayed on the Timer to indicate that the output ON count alarm
value was exceeded.
Output ON Count Monitor Value ( on-c )
The monitor value is only displayed. It cannot be set. The value will be
between 0 x 1000 times and 9999 x 1000 times. (The rightmost three digits will
not be displayed.)