Step 2: removing the drive covers, Step 3: removing the 700h control assembly – Rockwell Automation 20D PowerFlex 700H to 700S Phase II Control Conversion (Frames 9...14) User Manual
Page 4
Publication 20C-IN001D-EN-P
4
Step 2: Removing the
Drive Covers
1. Remove the connection, power and conduit covers as indicated below. Save
screws for reuse.
Step 3: Removing the
700H Control Assembly
Important: Before removing connections and wires, mark the connections
and wires to avoid incorrect wiring during assembly.
1. Unplug the DPI cable and any I/O connections from the 700H Main Control
board.
2. Remove the three screws that secure the 700H control assembly to the drive.
3. Remove the 700H control assembly from the control frame.
L1
L2
L3
L1
L2
L3
U/T1 V/T2 W/T3 U/T1 V/T2 W/T3
(8 Screws)
(8 Screws)
L1
L2
L3
L1
L2
L3
U/T1 V/T2 W/T3 U/T1 V/T2 W/T3
L1
L2
L3
L1
L2
L3
U/T1 V/T2 W/T3 U/T1 V/T2 W/T3
(3 Screws)
Connection Cover
Power Cover
Conduit Cover
Note: You do not need to remove
the enclosure cover. Enclosure is
illustrated without the cover for
clarity only.