UVP BioChemi System with EpiChemi II Darkroom - Manual (Page 17)

3. AC in Connector (power input)
• Connect to a wall outlet using the AC power
cord supplied
The printer power cable should plug
directly from the printer into the wall or
a power strip. The data cable for the
printer is a 25-pin parallel connector.
This 25-pin connector will plug into the
female equivalent in the back of the
computer.
Find the open 25 pin female slot, this is
the printer port. As soon as this port
has been identified, locate the Security
Dongle, supplied with the software
package. This will be a small “key” that
will fit between the computer and the
printer cable. When you have secured
this dongle onto the printer port on the
back of the computer, plug the printer
cable directly into the back of the
dongle.
Warning: Incorrect placement of this
key can lead to damage of the key.
Please be sure to plug it into printer
port only.
Once the computer end of the
cord is secured, locate the other end
and plug it into the designated port on
the printer. Plug in and secure the
clips.
dongle
Printer Driver Installation
To add a printer to the computer for the BioChemi:
1. Go to the START menu.
2. SETTINGS
3. PRINTERS
4. Choose ADD PRINTER. This will take you through the printer set up
wizard.
5. When asked for a driver, choose HAVE DISK.
6. Select BROWSE.
7. Choose Labworks CD Rom drive
8. Go to Drivers folder & then to printer drivers folder
9. Select the appropriate operating system, choose OK. Follow the
wizard’s instructions.
WWW.UVP.COM US Technical Support: 1.800.452.6788
UK Technical Support: +44.0.1223.420022
17