UVP GelMax Imager User Manual
Gelmax, Imager, Installation and user instructions
GelMax
™
Imager
Installation and User Instructions
UVP, LLC
Ultra-Violet Products Ltd.
2066 W. 11th Street
Unit 1, Trinity Hall Farm Estate
Upland, CA 91786
Nuffield Road, Cambridge CB4 1TG UK
Phone: (800) 452-6788
Phone: +44(0)1223-420022
Fax: (909) 946-3597
Fax: +44(0)1223-420561
Web Site: www.uvp.com
81-0351-01 Rev A
This manual is related to the following products:
Table of contents
Document Outline
- Web Site: www.uvp.com
- Table of Contents
- Introduction
- System Components
- Setup Instructions
- Components
- Connecting the Power and USB Cables
- Plug the square end of the USB cable into the back of the GelMax. Plug the other end into an available USB port on the user’s computer.
- Plug the main power cable into the back of the GelMax and the other end into a surge-protected power outlet. Set the power switch on the back of the system to the ON (I) position.
- Installing Emission Filters
- Installing the Doc-ItLS Acquisition and Analysis Software
- Using the System
- Service Procedures