UVP BioChemi System with EpiChemi II Darkroom - Manual (Page 10)

4. To remove the computer cover,
remove the screws from the back of
the case and slide the case off the
computer.
5. Install the Capture Kit board into the
PCI slot.
Take the new board out of the anti-
static bag. Hold it by the edges to
prevent damage to the components or
the edge connectors (the gold-colored
“fingers” that extend from the board).
6. Still holding it by its edges, gently but
firmly seat the “fingers” into the PCI
slot. Avoid touching the “fingers”
themselves or any component part on
the board. When the board is seated in
the slot, secure the card to the chassis
with the screw provided.
7. Replace the computer cover by sliding
the cover back into place, and use the
screws to refasten it onto the chassis.
WWW.UVP.COM US Technical Support: 1.800.452.6788
UK Technical Support: +44.0.1223.420022
10