Regency Horizon HZ42STE Medium Gas Fireplace - Manual (Page 49)

Regency Horizon™ HZ42STE Gas Fireplace
49
INSTALLATION
FACEPLATE INSTALLATION
1) Hook the fl ange on the back of the faceplate over the top edge of
the glass door - as shown below.
2) The height at which the faceplate sits may be adjusted to maintain
an even space between the upper faceplate and
lower faceplate panel.
The upper faceplate can be raised up once the
lower faceplate panel is in position - by adjusting the 2 screws
at the back of the upper faceplate - see below
(requires an extended phillips head screw driver)
.
The bottom panel of the faceplate installs on the unit with 2 slides.
These slides are located in the bottom of the unit - already installed
within the outer slide. The inner slides need to be removed to install
them on the brackets.
Glass Door Faceplate
3) Pull out inner slide from the outer slide.
4) Push done on the black lever on the outside of the inner slide - this will
release the inner slide. Pull inner slide completely out - from outer slide.
5) Lay out the brackets for the lower faceplate to identify the left and
right brackets.
Left Bracket Right Bracket
6) Install the brackets onto the lower faceplate.
Note
: Installation location of the left and right brackets is the same for
both the HZ42 and HZ42ST.
Right bracket shown in position on lower faceplate.
Top of lower
faceplate