beautypg.com

Installation – Regency Horizon HZ42STE Medium Gas Fireplace User Manual

Page 39

background image

Regency Horizon™ HZ42STE Gas Fireplace

39

INSTALLATION

13) Program Receiver and transmitter (refer to manual)

Note: DO NOT USE 4 AA batteries in the battery pack on the tray; the
DFBC is now powered by the receiver batteries in the wall.

12) Connect GTM motor wire from the stepper motor to the wire connector

from the receiver wire harness.

10)

Install 4 - AA batteries into the receiver, ensure correct polarity.

9)

Install the ground wire to the ground lug just behind and to the left of the

valve on the HZ42E and to the right of the valve on the HZ42STE.

14)

Install the receiver in the wall or if that is not possible - to the tray.

15)

HZ42E Only: Manoeuvre the tray into the base of the unit using the

stops to guide how far back the tray sits.

HZ42STE Only: Manoeuvre the tray into the two L brackets on the backside

of the front wall of the unit base.

HZ42E Only:
16)

Install the heat shield over the tray by slotting tabs into slots located the

location shown below.

11)

Plug receiver wires into the back of the receiver and bundle wires

with the wire clip as shown below.

HZ42E

HZ42E

HZ42E

HZ42STE

HZ42STE

HZ42STE