Stainless Works Chevy SS 2014 Headers - Manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
INSTALLATION INSTRUCTIONS FOR 2014 CHEVY SS HEADERS
Thanks for purchasing Stainless Works Muscleflow Headers for your 2014 Chevy SS
6.2L. We have gone to great pains to make sure that our exhaust systems fit and sound
great. Please follow these steps to ensure that your installation goes as planned.
1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket
maker as an option to or in conjunction with the use of factory gaskets. The
recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or
Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.
2. Disconnect the battery before starting work on the exhaust system for your
vehicle. Reconnect the battery when the job is completed.
3. Your exhaust system can be installed by a weekend warrior but the use of a lift is
recommended for ease of installation. If using a jack, the vehicle must be placed
on a level hard surface and jack stands are required for safety reasons.
4. You will assemble the components together as specified below, but only snug the
clamps as you move along from front to back. When placing the X-pipe (if part of
your system) into position, make certain that you push it fully forward and level it
in with the vehicle. After aligning all the components in the vehicle, you will
tighten all the clamps working from front to back of the vehicle.
5. Raise and support the vehicle.
6. Remove ball clamps at the front of the mufflers and remove mufflers.
7. Remove (4) 10 mm bolts from cross brace and remove.
8. Remove tailpipes from the rubber hangers.
9. Unbolt (4) 10 mm nuts, 2 per side from exhaust connection flanges behind the
OEM catalytic converters.