Stainless Works Ford Raptor 2011+ 6.2L Lightning Exhaust - Manual (Page 2)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
8. Cut pipe at the above mark with a hacksaw and remove the sharp edges.
9. Reinstall the flanged section cut above, using the (2) 10 mm bolts removed
earlier.
10. Install Stainless Works Y-pipe into the new muffler using (2) 3” clamps. Do not
fully tighten.
11. Install Y-pipe with muffler to the above factory pipe using (1) 3” clamp. Do not
fully tighten.
INSTALLING THE CATBACK TO HEADERS ONLY
12. For installing to Stainless Works headers only - install 30” long muffler (with
internal X-pipe) to header lead pipes using (2) 3” clamps. Do not fully tighten.
INSTALLING THE CATBACK TO EITHER HEADERS OR TO MANIFOLDS