Stainless Works Ford Mustang GT 2010 Exhausts User Manual
Page 2
Place the two pieces of supplied Koolmat wrap around the EVAC tube at the top of
the passenger side over axle using three supplied zip ties on each. This will provide
extra assurance that the EVAC tube will not melt. Adjust tailpipe so there is a min of
½” clearance between the wrapped EVAC tubes and the over axle. See before and
after pictures below:
Unwrapped EVAC Tube
Wrapped EVAC Tube (picture #1)
Wrapped EVAC Tube (picture #2)
11. Tighten overaxles and mufflers, reinstalled the hanger brackets.
12. Install tips and clamps making sure to have clearance around the tip between the
tip and valence.
13. Start car outside and warm up thoroughly. It will be normal for the exhaust
system to smoke for approximately 5-10 minutes. The smoke is due to lubrication
used in the manufacturing process and the vehicle should be allowed to run
outside.
14. Let the vehicle cool thoroughly and re-tighten all clamps.
WWW.STAINLESSWORKS.NET
800-878-3635
FAX: 440-543-9183