Stainless Works Dodge Challenger SRT8-RT 2008+ Catback - Manual (Page 2)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
6. Slide (2) supplied round hangers in rubber grommets behind mufflers and slip
over muffler outlets then slide tail pipes on to muffler outlets.
7. Install blue grommets in clamp hangers supplied in kit and slip over tail pipes
with the clamp-bolt side of the clamp, facing to the outside of car.
8. Using 3/8 x 1 ½ long bolts and locknuts hang tailpipes on hangers.
9. Slide two 3” clamps over the tips and slide polished tips over tailpipes and center
them in the valence cutouts and tighten. If you opted for use of the OEM tips,
you will need to insert the adapter with ball flares on the tailpipes instead of the
quad tips, then install the factory tips.
10. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the system, it will melt. Make sure to have at least ½” of
clearance and wrap any suspect areas with DEI thermal barrier wrap.
11. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.