Stainless Works Dodge Challenger 2008-12 SideBurners Modular-Exhaust - Manual (Page 3)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
9. Install the side exhaust tip onto the hangers using one 3/8” flat washer and nyloc
nut for each side. Do not tighten yet.
10. Apply a ¼” to 3/8” dia. bead of silicon around the drilled holes at both locations.
Install Sideburners onto factory exhaust pipes, and lightly snug up the clamps.
11. Tighten the hangers holding the tips in place (see picture below).
12. Tighten the clamps holding the Sideburners inlets to the factory exhaust.
13. Be sure to have adequate clearance around all wires, hoses and lines. If anything
is in contact with the exhaust system, it will melt. Make sure to have at least
½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
14. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances.