Stainless Works 450-264 Ford Mustang 5.0 2011+ AIRAID Intake System - Manual (Page 2)

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Before! After!
Don’t Forget Your AIRAID Filter Tune-Up Kit!
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned using the Airaid Filter Tune-Up Kit periodically.
13. Reconnect the Mass Air Flow sensor, which is now
located in the lower back side of the intake. Slide the
locking tab back into the connector. 14. Install the Weather Strip (#9) onto the CAB with the
contoured edge going away from the filter. Start at the
front of the vehicle and work your way back. Replace the
engine cover.
10. Install the Silicone Reducer (#6) and Hose clamps
onto the throttle body. Place the #56 clamp (#15) on the
Throttle body side of the reducer, and the #64 clamp
(#14) on to the tube side. 11. Install the Airaid Intake Tube into the couplers as
shown, and tighten all Hose clamps. A) Reconnect the
Resonator tube to the Airaid Intake using the OEM
clamp. B) Reconnect the breather line/lines to the Alumi-
num Fittings depending on your application. 12. A) Install the Airaid Premium Filter (#1) onto the
filter adapter and tighten the hose clamp. B) re install the
Resonator tubing into the factory Stand off.
B.
B.
A.
15. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Double check the hood
clearance!
Reconnect the negative battery cable!
Optional Installation Notice!
Airaid has made it possible to eliminate the factory in-
duction roar resonator if you so desire. The removal of
the resonator from the intake has no negative effect on the
performance of this kit.
Remove the entire Resonator tube assembly and all asso-
ciated stand offs from the intake tube to the Fire wall.
A.) Install the Urethane cap (#7) with the 60mm Hose
Clamp (#16) onto the Airaid Intake tube.
B.) Snap the Firewall plug (#17) into the firewall hole.
A.
B.
Instructions Revision
Date: 06/13/11