Skyjacker 7211 - Manual (Page 3)

I-7211 Pg 3
10. Measure from the base of the inner tie rod 12 9/32" & mount the new
Skyjacker center bracket parallel with the angle of the OEM center
link steering stabilizer mounting hole using the 5/16" x 1 3/8" x
2 3/16" u-bolts, washers, nuts, & 1/2" socket. (See Photo # 5 & 6)
11. Install the 5/8” hourglass bushings into each end of the new Skyjacker
steering stabilizers & mount with the shaft end of the new sterring
stabilizers towards the inside using the washers, nuts, & 3/4" socket.
(See Photo # 7)
12. Position the torsion bar puller & load the adjuster arm until the
adjuster nut can be installed to the torsion bar cross member using a
21mm socket. (See Photo # 1) Repeat this process on the opposite
side. Note: Be sure to install the adjuster bolts to the same length as
the OEM when removed in Step # 5.
13. Using a floor jack, remove the jack stands from under the frame
rails & lower the vehicle to the ground.
Final Notes:
• Cycle the steering of the vehicle left to right & check all parts for adequate clearance.
• After the first 100 miles, check all of the hardware for the proper torque.
Seat Belts Save lives, Please Wear Your Seat Belt.
Photo # 5
Photo # 6
Photo # 7