Skyjacker 9239 - Manual (Page 3)

11. Install the new Skyjacker polyurethane bushings into each end of the
new Skyjacker steering stabilizers. Attach the new steering stabilizers
onto the new studs & tighten. (See Photo # 5)
12. Once the steering stabilizers are installed, check all the brackets &
bolts for proper installation. (See Photo # 6)
Final Notes:
• After the installation is complete, double check that all nuts
& bolts are tight. Refer to the following chart for the proper
torque specifications. (Do not retighten the nuts & bolts
where thread lock compound was used.)
• Cycle the steering of the vehicle left to right & check all parts
for adequate clearance.
• After the first 100 miles, check all of the hardware for the
proper torque & periodically thereafter.
Seat Belts Save lives, Please Wear Your Seat Belt.
I-7239 Pg 3
Photo # 5
Photo # 6
ToRque SPeCiFiCATioNS
iNCH SYSTeM
Bolt Size Grade 5 Grade 8
5/16 15 FT LB 20 FT LB
3/8 30 FT LB 35 FT LB
7/16 45 FT LB 60 FT LB
1/2 65 FT LB 90 FT LB
9/16 95 FT LB 130 FTLB
5/8 135 FT LB 175 FT LB
3/4 185 FT LB 280 FT LB
MeTRiC SYSTeM
Bolt Size Class 8.8 Class 10.9
6MM 5 FT LB 9 FT LB
8MM 18 FT LB 23 FT LB
10MM 32 FT LB 45 FT LB
12 MM 55 FT LB 75 FT LB
14MM 85 FT LB 120 FT LB
16MM 130 FT LB 165 FT LB
18MM 170 FT LB 240 FT LB
• The above specifications are not to be used when the bolt is being installed with a bushing.