Skyjacker TU710R User Manual
Page 4
Rear Installation:
8. If installing rear block and U-Bolt kit. Block the front tires and
raise the rear end using floor jack. Properly support frame rails
using jack stands. Remove rear tires / wheels.
9. Remove rear shocks. (See Photo #8). Remove rear u-bolts and
lower rear end enough to allow for installation of the rear lift
block. With block installed, raise rear end up and install new u-
bolts.
10. With u-bolts tight, re-install shocks, tires / wheels and lower to
the ground.
11. With install complete, measure lift height gained. The front can
be adjusted up or down for desired lift. Once adjusted, tighten
the spanners and have vehicle aligned.
* After install is complete, check all hardware and parts for
accurate installation. Be sure all bolts are tight and properly
installed.
* Vehicle must be aligned by a qualified alignment facility.
* Check all bolts for tightness after the first 100 miles.
*Seat Belts Save Lives, Please Wear Your Seat Belt*
Photo #8
Photo #7
I-TU730