Skyjacker RRCS2-S - Manual (Page 3)

16. Hold adjusting bolt (A) on the lower A-Arm, and remove the self-
locking nut (C) and adjusting cam (D). (See Image #10)
18. Remove adjusting bolt and lower A-Arm down.
19. Remove the three flange bolts (A) from top of the damper, remove
damper assembly (B). (See Image #11)
20. Attach new rear spacer to the factory frame mount using the
10x30mm bolts with a 1.25 thread pitch provided. (See Image #12)
With upper bracket installed, attach damper using the 10x30mm
bolts and nuts supplied. One washer will be used under the nut.
21. Re-Install lower A-Arm assembly in reverse order of removal. Torque
all hardware to factory specs shown in previous images. With all
parts installed, raise lower A-Arm so that vehicles weight is on
damper assembly. Torque the 3 upper damper bolts to 45 Ft. Lbs
.
22. With all parts installed and properly tightened, reinstall wheels and
lower vehicle to the ground.
FINAL NOTES:
• After installation, a qualified alignment center is required to properly
align the vehicle.
• Have Headlights adjusted to proper setting.
• With vehicle on the ground check clearances on all moving parts,
wheels, tires, etc. Be sure to check brake lines for proper length and
any damage.
• Re-Torque all bolts after the first 100 miles and periodically there after.
Seat Belts Save Lives, Please Wear Your Seat Belt!
Image #10
Image #11
Image #12
Page 3 of 3
HR 2 0