Skyjacker RRCS2-S - Manual (Page 2)

7. Attach damper assembly to the knuckle using the factory
pinch bolts. Do not tighten at this time. (See Image #5)
8. Install the wheel sensor harness clips (A) and the brake line
bracket (B) to the damper (C). (See Image #6)
9. Loosely attach the stabilizer link (D) to the damper. Raise
the front suspension with a floor jack to load the suspension
with the vehicles weight. Tighten the damper pinch bolts
and flange nuts. Torque to 156 Ft. Lbs. Torque upper bolts
in top of upper bracket to 45 Ft. Lbs.
10. Torque the stabilizer link nuts to 58 Ft. Lbs.
11. Install factory service caps and front wheels.
REAR INSTALLATION:
12. Raise the rear of the vehicle and properly support using
jack stands. Remove the rear wheels.
13. Position a floor jack at the connecting point of the lower
arm (B) and the knuckle. (See Image #7)
14. Remove the locknut (B), washer (C) and flange bolt (D).
(See Image #8).
15. On lower A-Arm, Remove locknut (A), then remove flange
bolt (C). Remove flange bolt (D), and lower the floor jack
gradually. (See Image #9)
Image #5
Image #6
Image #8
Image #7
Image #9
Page 2 of 3