Skyjacker FAA281 - Manual (Page 3)

7. Remove the OEM bushings & sleeves from the OEM lower A-arms.
(See Photo # 4)
8. Apply a thin layer of grease to the new Skyjacker bushings & OEM
sleeves & install them into the new Skyjacker lower A-arms.
9. Install the new Skyjacker lower A-arms to the frame using the OEM
hardware & two 15mm wrenches. (See Photo # 5)
10. Attach the new Skyjacker lower A-arms to the OEM steering knuckles
using the OEM hardware & a 15mm wrench.
11. Compress the OEM front strut coil springs using a strut spring
compressor. Remove the OEM upper strut mount retaining hardware
using a 3/8" wrench & 19mm wrench. Remove the OEM strut
assemblies from the upper frame mounts. (See Photo # 6)
12. Remove the OEM upper strut retaining hardware using a 3/8" wrench
& 19mm wrench. Remove the OEM strut coil springs from the OEM
strut assemblies. (See Photo # 7)
13. Remove the OEM brake line retaining clamps from the OEM strut
assembly housings & loosen the pinch bolts on the OEM strut
assembly housings using a 13mm wrench. (See Photo # 8)
14. Remove the OEM struts from the OEM strut assembly housings.
15. Install a new Skyjacker lower stut body spacer into the bottom of each
OEM strut assembly housing. (See Photo # 9)
I-FAA281 Pg 3
Photo # 4
Photo # 5
Photo # 6
Photo # 7
Photo # 8 Photo # 9