Sensaphone 1400 - Manual (Page 80)

Sensaphone 1400 Manual
78
CALL PROGRESS
The 1400 monitors call progress when it dials out for an alarm.
If 1400 encounters a busy signal or receives no answer after ten
rings, the unit hangs up, waits the programmed intercall time and
then dials the next phone number. When dialing some beeper/pager
services, the line may be answered before receiving a ringback.
This may interfere with the call progress detection and result in a
failed call to certain phone systems or beeper/pager services. If this
occurs, disable call progress detection. Default setting is Enabled.
To enable/disable call progress detection:
1. Press the SENSOR ON/OFF key.
2. Press the STATUS/CONFIG key.
The 1400 will respond “Call Progress Enabled/Disabled” to indicate
that call progress has been turned on or off respectively.
3. Repeat key sequence to change.