Sensaphone 1400 User Manual
Page 49
Chapter 4: Zone Programming
47
DESIGNATING A ZONE AS UNUSED
This feature allows you to mark selected Zones, Power, or Sound
as unused, which will prohibit them from going into alarm and will
also leave them out of the status report. Note that programming
for the selected Zone will be preserved when the Zone is marked
as “unusued” and will not be reconfigured if automatic Zone
configuration is activated.
If the sensor is configured as not used, the unit will respond “Error
the zone is off ”. Refer to section 5.13 to designate as used.
1. Press the SENSOR ON/OFF key.
2. Press the SET key.
The 1400 will say “Enter Zone Number.”
3. Press the corresponding number of the Zone you wish to mark
as unused.
The 1400 will respond by saying Zone 1–4, Power, or Sound “Off/
On.” Repeat the key sequence to place the Zone back in use.