Sensaphone 1400 - Manual (Page 76)

Sensaphone 1400 Manual
74
CALL DELAY TIME
The call delay time is the length of time the 1400 will announce an
alarm before it starts the dial-out sequence. This only applies to the
first call. To set delay time between calls, see INTERCALL TIME.
The default call delay time is 30 seconds. It can be programmed
from 0 to 60 minutes. The purpose of Call Delay is to allow time for
personnel at the 1400’s installation site to respond to and cancel an
alarm before dial-out begins. During this time, the unit will audibly
repeat its “alarm” message and the front panel alarm LED will
blink.
To program call delay time:
1. Press the SET key.
2. Press the CALL DELAY key.
The 1400 will say “Enter minutes.”
3. Enter the number of minutes using the number keys. Then press
ENTER. To keep the previous setting, just press ENTER.
The 1400 will say “Enter Seconds.”