Sensaphone 1400 - Manual (Page 58)

Sensaphone 1400 Manual
56
ID NUMBER
The ID Number is the identification number of the 1400. This
number is typically the telephone number where the unit is installed,
or it may be designated using any number that best suits your
application. The purpose of the ID Number is to immediately
provide the source of any alarm, especially when using multiple
1400 units in a complex monitoring system. The ID number is
announced during voice alarm messages and displayed on pagers.
The ID Number can be up to 16 digits long.
When the 1400 is called from a remote location, it always begins
its message with the identification number: “Hello, this is (ID
Number).” If no ID Number is programmed, the unit will say,
“Hello, this is Sensaphone 1400.”
To program the ID Number:
1. Press the SET key.
2. Press the ID key (number 0 key).
3. The unit will say “Enter ID number.” Using the number keys,
enter the unit’s phone number, then press ENTER.
If the number was accepted, the 1400 will say “OK.”