SATEC PM135 Manual - Manual (Page 96)

‎Chapter 5 Configuring the PM135 Configuring Meter Security
96 PM135 Powermeter Series
To change the password:
1. Select the Password Setup entry
from the Device Setup menu using
the UP/ DOWN buttons.
2. Press the ENTER button to enter
the "Password Setup" menu.
3. Select "Password Value" with the UP
/DOWN and ENTER buttons to
access the password value field.
4. select the desired digit using the
UP/DOWN button and move to next
digit by pressing the TAB button
5. Press ENTER button when desired
password value is achieved that
returns to "Password Value" field
The new password is effective for both the display and
communication ports.
To enable or disable password protection:
1. Select "Password Enabled" field
using the UP /DOWN buttons.
2. Press the ENTER button to enter
the "OFF/ON Password Enabled"
display.
3. Use the UP/DOWN buttons to
select the option:
ON enables password protection and
OFF disables password protection.
4. Press ENTER to confirm your new
setting.
5. Press ESC to exit the menu.
When password protection is enabled, you are not able
to change the device settings through the display or
communications unless you provide a correct password.
If you cannot provide a proper password, contact your
local distributor for the appropriate password to override
password protection.