SATEC PM135 Manual User Manual
Page 118

Chapter 6 Device Control and Upgrading
Upgrading Device Firmware
118
PM135 Powermeter Series
5. You are asked for the password
regardless
of
the
password
protection setting in your meter.
Type the meter password, and click
OK. If you did not change the
password in the meter, enter the
default password 0.
6. Observe the PM135 Display screen
with "Flash Loader Running…"
notification as below
7. Wait until PAS completes upgrading
your device. It takes about 3-4
minutes at 115,200 bps to download
the file to the meter.
8. After
upgrading
firmware
is
completed, the meter restarts, so
communications can be temporarily