Brother NC8100H - Manual (Page 102)

CHAPTER 9 NOVELL NETWARE PRINTING
9-15
18. Execute the BRCONFIG from the Windows ® menu or insert the CD-
ROM that came with your FAX/MFC into the CD-ROM Drive of your
PC and type: X:BRCONFIG (X: is the drive letter of your CD-ROM
Drive).
Select the Print / Fax server from the list of Print / Fax servers. When
you get the message that the Print / Fax server is connected, press the
ENTER key and type the default password of "access" in response to the
"#" prompt (the password will not echo), and then press the ENTER key
again in response to the ENTER Username> prompt. When you get the
Local> prompt, type:
SET SERVICE service TREE tree
SET SERVICE service CONTEXT Context
•
Where tree is the NDS tree name.
•
Where context is the name of context where the Print / Fax server
resides.
•
Service is the name of the service assigned by NetWare Print / Fax
server name (where the default services are BRN_xxxxxx_P1 for
the Brother printer, where "xxxxxx" is the last six digits of the
Ethernet address (MAC address).
•
You can also enter the TREE and CONTEXT name using your web
browser by connecting to the Brother Print / Fax server using the
TCP/IP protocol and selecting the NetWare protocol configuration.
19. Use the BRCONFIG command or TELNET command: SET NETWARE
RESCAN to force the Print / Fax server to rescan for file servers, or
power cycle the printer.
The same services assigned by NetWare Print / Fax server names cannot be used
for both queue server mode and remote printer mode.
The same service assigned by NetWare Print / Fax server cannot be used for both
queue server mode and remote printer mode. If you want to enable remote printer
capabilities on a service other than the default NetWare service, you must define
new services that are enabled for NetWare and for the desired port. Refer to
Appendix B in this manual for information on how to do this.