Brother NC8100H User Manual
Page 17
CHAPTER 1 TCP/IP CONFIGURATION
1-3
Using BRAdmin and the IPX/SPX Protocol
to set the IP address
If your PC has Novell Netware Client software and is using the IPX/SPX
protocol, do the following:
1. Select IPX/SPX filter in the left frame of the main window.
2. Check the Print / Fax server name (the default node name will be
BRN_xxxxxx, where "xxxxxx" is the last six digits of the Ethernet
address (MAC address)).
If you cannot find your server name, select the "Device" menu and choose
"Search Active Devices" (you can also press the F4 key) and try again.
You can find the node name and MAC address by printing out the FAX/MFC
configuration page. Refer to the NC-8100h Quick Setup Guide for information
on how to print the configuration page on your Print / Fax server.
3. Select the Print / Fax server that you wish to configure and double click
it. You will be asked for a password. The default password is "access".
4. Select the TCP/IP tab and set the IP address, Subnet mask and Gateway
as needed.
5. Click
OK.