Brother NC8100H - Manual (Page 171)

APPENDIX
A-2
TELNET
To connect to the Print / Fax server using TELNET on UNIX,
Windows
® NT ® , or most other TCP/IP systems, type: TELNET
IP address at the command prompt of the system prompt, where
ipaddress is the IP address of the Print / Fax server. When you
are connected, push RETURN or ENTER to get the "#" prompt,
enter the password "access" (the password will not appear on
the screen), and type anything in response to the Enter
Username> prompt. When you see the Local> prompt, you are
ready to enter commands.
Enter HELP at the command prompt for a list of supported
commands.
BRCONFIG
Brother BRCONFIG utility runs on the DOS system prompt and
is installed with BRAdmin. To connect the Print / Fax server
using the Brother BRCONFIG NetWare utility, Choose the
BRCONFIG utility from the Brother BRAdmin utilities. If you
have only one Print / Fax server, you will be immediately
connected to that server. If you have more than one Print / Fax
server, you will be given a list of available Print / Fax servers.
Type the number of the Print / Fax server to which you wish to
connect. When you are connected, enter the password "access"
(the password will not appear on the screen) at the "#" prompt,
and type anything in response to the Enter Username> prompt.
When you get the Local> prompt, you are ready to enter
commands. To use BRCONFIG, a Novell Server (running the
IPX protocol) is necessary and an active connection must be
made to the server.
Enter HELP at the command prompt for a list of supported
commands.