MacDon R85 Rotary Disc 13 Foot Pull-Type - Manual (Page 93)

MAINTENANCE AND SERVICING
Form 169454
91
Revision A
7.13 MAINTENANCE SCHEDULE
The following maintenance schedule is a listing
of periodic maintenance procedures, organized
by service intervals. Regular maintenance is the
best insurance against early wear and untimely
breakdowns. Following this schedule will
increase machine life.
For detailed instructions, refer to the specific
headings in Section 7 MAINTENANCE AND
SERVICING.
Use the fluids and lubricants specified in Section
7.3.1 Recommended Lubricants.
Service Intervals: The recommended service
intervals are in hours of operation. Where a
service interval is given in more than one time
frame, e.g. "100 HOURS OR ANNUALLY",
service the machine at whichever interval is
reached first.
IMPORTANT
Recommended intervals are for average
conditions. Service the machine more
often if operated under adverse conditions
(severe dust, extra heavy loads, etc.).
CAUTION
Carefully follow safety messages given in
Section 7.1 PREPARATION FOR SERVICING,
and Section 7.2 RECOMMENDED SAFETY
PROCEDURES.
7.13.1 Break-In Inspections
BREAK-IN INSPECTIONS
HOURS ITEM CHECK
1 Wheel Bolts Torque 120 ft·lbf (160 N·m)
5
Drive Belt Tension
Hardware Torque. Refer to Section 7.3.1 Recommended Torques
25
Drive Belt
Tension
50
Drive Belt
Cutterbar Lubricant Change. Use only specified amount. Do not overfill.
Bevel Gearbox Lubricant
Pump Gearbox Lubricant
Change
100
Hydraulic Oil Filter
150
Bevel Gearbox Lubricant
Cutterbar Lubricant
250
Cutterbar Lubricant