MacDon R85 Rotary Disc 13 Foot Pull-Type - Manual (Page 86)

MAINTENANCE AND SERVICING
Form 169454
84
Revision A
7.10.4.2 Installation
a. Remove covering from gearbox.
b. Apply SAE multi-purpose extreme pressure
grease to pump spline (H), and position pump
(G) on gearbox.
c. Re-install four bolts (F) (shown on previous
page), and torque to 92 ft·lbf (125 N·m).
d. Remove caps from pressure fitting (E) and hose
end, and attach pressure hose to pump. Tighten
fitting. See illustration on opposite page.
e. Remove plug from suction fitting (J) on pump.
f. Remove plug from supply hose, and attach to
pump fitting. Secure with clamp (D) (shown on
previous page.
g. Remove plug from lower case hose (C), and
attach to pump fitting.
h. Fill pump case with clean hydraulic oil at fitting
(K).
i. Attach case drain hose to fitting (K), and tighten.
j. Install hose straps (A).
k. Check reservoir oil level, and add oil if required.
See Section 7.10.1 Reservoir.
K
A
H
E
J
C
G