MacDon R85 Rotary Disc 13 Foot Pull-Type - Manual (Page 58)

MAINTENANCE AND SERVICING
Form 169454
56
Revision A
7.3.2 Recommended Lubricants
Your machine can operate at top efficiency only
if clean lubricants are used.
• Use clean containers to handle all
lubricants.
• Store in an area protected from dust,
moisture, and other contaminants.
IMPORTANT
Do not overfill the cutterbar when
adding lubricant. Overheating and
failure of cutterbar components may occur
if overfilled.
LUBRICANT SPEC. DESCRIPTION USE CAPACITIES
Grease
SAE
Multi-Purpose
High Temperature Extreme
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2). Lithium Base
As Required Unless
Otherwise Specified.
---
High Temperature Extreme
Pressure (EP) Performance With
10% Max Molybdenum Disulphide
(NLGI Grade 2). Lithium Base
Driveline Slip-Joints ---
NLGI 00 Synthetic EP
Conditioner Drive
Gearbox
Lubricated
For Life
16 oz.
(454 grams)
Gear
Lubricant
Traxon SAE
LS 80W90
High Thermal and Oxidation
Stability.
API Service Class GL-5
Cutterbar
3.4 quarts US
(3.25 liters)
Pump Drive Gearbox
2.1 quarts
(2.0 liters)
Traxon
E 75W90
Fully Synthetic Gear Lubricant.
API Service Class GL-5.
Bevel Gearbox
0.41 quarts US
(400 ml)
Hydraulic Oil
Single Grade
Trans-Hydraulic Oil *
** See Below For List of
Recommended Brand Names.
Hydraulic Drive
Systems
39 gal. US
(147 liters)
* For Australian Units - Use SAE 15W40 complying with SAE specs for API Class SJ and CH-4 engine oil.
** The following oil company and equipment manufacturer brand names are recommended:
Petro Canada Duratran Case IH Hy-Tran Plus®
John Deere Quatrol® J20C Agco Power Fluid 821XL
** The following oil company and equipment manufacturer brand names are acceptable:
New Holland Hydraul Esso/Exxon Hydraul 56
Shell Donax TD