MacDon R85 Rotary Disc 13 Foot Pull-Type - Manual (Page 34)

OPERATION
Form 169454
32
Revision A
6.12 TRANSPORTING MOWER
CONDITIONER
The R85 Mower Conditioner can be transported
on public roads by towing with a tractor or a
truck. Proceed to Section 6.12.1 Transporting
With A Tractor, or 6.12.2 Transporting With A
Truck.
CAUTION
• Be aware of roadside obstructions,
oncoming traffic and bridges.
• Travel speed should be such that
complete control and machine stability
are maintained at all times. Do not
exceed 20 mph (32 km/h). Reduce speed
for corners and slippery conditions.
• When transporting on roads, use tractor
lights and mower conditioner flashing
amber and red tail-lights to provide
adequate warning to operators of other
vehicles.
• Do not transport the mower conditioner
on a road or highway at night, or in
conditions, which reduce visibility, such
as fog or rain.
6.12.1 Transporting With A Tractor
If the mower conditioner is in Transport Mode,
proceed as follows. Otherwise, see Section
6.12.3 Preparing Mower Conditioner For
Transport.
a. Hook-up mower conditioner to tractor. See 6.4
MOWER CONDITIONER/TRACTOR HOOK-UP
for details on attaching the mower conditioner to
the tractor.
NOTE
The hydraulic hoses do not need to be
attached to the tractor for towing. Ensure
they are securely stored on the APT.
NOTE
The PTO does not need to be attached for
towing purposes. If not attached, lower
hook (A), store driveline (B) on hook, and
remove forward half of driveline. Store
forward half in cab for transport.
b. Ensure that APT safety chain is properly
attached to towing vehicle. Provide only enough
slack in chain to permit turning.
c. Check local laws for width regulations and
lighting or marking requirements before
transporting on roads.
d. Do not exceed 20 mph (32 km/h).
6.12.2 Transporting With A Truck
CAUTION
Do not tow with a vehicle weighing less than
7500 lb (3400 kg). Ensure that the capacity
of the towing vehicle is sufficient to maintain
control.
If the mower conditioner is in Transport Mode,
proceed as follows. Otherwise, see Section
6.12.3 Preparing Mower Conditioner For
Transport.
a. Store hydraulic hoses on the APT as shown
opposite.
b. Lower hook (A), and place driveline in hook.
c. Remove the forward half (B) of driveline, and
store in truck for transport.
(continued next page)
A
B