beautypg.com

MacDon R85 Rotary Disc 13 Foot Pull-Type User Manual

Page 84

background image

MAINTENANCE AND SERVICING

Form 169454

82

Revision A

7.10.2 Hydraulic Oil Filter

NOTE

Change hydraulic oil filter after the first
100 hours operation, and every 250 hours
thereafter.

a. Clean around the filter head (A).

b. Remove the filter (B), and clean the gasket

surface of the filter head.

c. Apply a thin film of clean oil to the gasket on the

new filter.

d. Install new filter. Turn the filter onto the mount

until the gasket contacts the filter head. Tighten
the filter an additional 1/2 to 3/4 turn by hand.

IMPORTANT

Do not use a filter wrench to install the
filter. Over-tightening can damage gasket
and filter.

7.10.3 Pressure Relief Valve

A possible cause of poor cutting performance
and/or excessive heating of hydraulic oil is low
relief pressure.

The relief valve (C) is factory-set at 6000 psi
(41.37 MPa). See your Dealer for adjustment or
service.

C

B

A