MacDon R85 Rotary Disc 13 Foot Pull-Type - Manual (Page 89)

MAINTENANCE AND SERVICING
Form 169454
87
Revision A
7.11.2 Fixture Replacement
7.11.2.1 Hazard Lights
a. Cut plastic cable ties (A) securing harness
covering to light (B).
b. Retrieve connections (C) from inside harness
covering (approximately 6 inches (150 mm) from
light), and disconnect wires. Remove tape (if
necessary).
c. Remove the two nuts (D) securing light to
bracket, and remove light. Pull wires through
hole in bracket.
d. Feed connectors of new light (B) through hole in
bracket, and position light onto bracket.
e. Install nuts (D), and tighten.
f. Connect wires to connectors (C) in harness, and
re-secure harness covering with tape and plastic
tie (A) as required.
7.11.2.2 Tail/Brake Lights
a. Cut plastic cable tie (A) securing harness
covering to light (B).
b. Retrieve connections (C) from inside harness
covering approximately 6 inches (150 mm) from
light, and disconnect wires. Remove tape (if
necessary).
c. Remove nut (D) securing light to frame, and
remove light. Pull wires through hole in frame.
d. Feed connectors of new light (B) through hole in
bracket, and position light onto frame.
e. Install nut (D), and tighten.
f. Connect wires to connectors (C) in harness, and
re-secure harness covering with tape and plastic
tie (A) as required.
D
A
C
B
A
D
B
C