MacDon A40-D Pull-Type - Manual (Page 162)

SECTION 7 MAINTENANCE AND SERVICING
169000
160
Revision F
l. Adjust roll timing. Refer to Section 6.17.12.2 Roll
Timing and Alignment.
m. Clean off excess sealant from motor flange and
gearbox face.
n. Apply light coat of silicone to motor flange, and
position motor on gearbox as shown until
mounting holes are aligned, and pinion engages
gear in gearbox.
o. Install bolts removed in Section 7.13.10, step b.
(A) and washers, and torque to 75 ft·lbf
(102 N·m).
p. Reconnect hoses to motor.
q. Close all shields before operating machine.