MacDon A40-D Pull-Type - Manual (Page 108)

SECTION 7 MAINTENANCE AND SERVICING
169000
106
Revision F
I. A30-D Headers
REEL SHAFT BEARING (1 PLC)
A30-D HEADER RH SIDE
High Temperature Extreme Pressure
(EP2) Performance With 1% Max
Molybdenum Disulphide
(NLGI Grade 2) Lithium Base.
KNIFE DRIVE BEARING (1 PLC)
AUGER SHAFT BEARING (1 PLC)
NOTE
To prevent binding and/or
excessive wear caused by knife
pressing on guards, do NOT
over-grease. If more than 6 to 8
pumps of grease gun are required
to fill the cavity, replace the seal in
the knife head.
KNIFE HEAD BEARING (1 PLC)