MacDon A40-D Pull-Type - Manual (Page 116)

SECTION 7 MAINTENANCE AND SERVICING
169000
114
Revision F
7.6.4 Installing Sealed Bearing
a. Clean shaft, and coat with rust preventative.
b. Install flangette (A), bearing (B), second
flangette (C), and lock collar (D).
NOTE
The locking cam is only on one side of
the bearing.
c. Install (but do NOT tighten) flangette bolts (E).
d. When shaft is correctly located, lock the lock
collar with a punch.
NOTE
The collar should be locked in the same
direction the shaft rotates. Tighten the
set screw in the collar.
e. Tighten flangette bolts (E).
f. Loosen flangette bolts on mating bearing one
turn, and retighten. This will allow the bearing to
line up.
C
D
E
A
B