MacDon 963 Harvest Header - Manual (Page 68)

67
UNLOADING & ASSEMBLY
INSTALL GAUGE WHEEL / TRANSPORT OPTION
(continued)
12. Assemble light package (continued):
c. At left endsheet, attach transport harness
ground wire (white) to ground for header lights
at (C).
d. Ensure wire cannot reach pulley. If necessary,
use small plastic tie at (D) to attach wire to
harness at left endsheet.
e. From right end, pull harness through frame
tube taut.
f. At the right hand end sheet, install lamp
module and support at (N) with the hardware
that secures the hydraulic line clamp.
g. Connect header harness and end sheet
harness to lamp module. Route longer section
of end sheet harness to top of end sheet
through hole at reel support arm anchor (S).
Route the shorter section of end sheet harness
to the inside of end sheet through hole at (P).
h. Install lights at right hand end sheet using the
hardware that secures the pivoting amber
lights. If shield (X) is installed, install spacer bar
(Q) at second bolt to level the mounting
surface. Make the wire connections according
to the schematic (next page). Cable tie harness
at (Y) as shown.
i. Install lights at R/H reel support arm using ½ x
1 inch carriage bolts and flange nuts.
j. Route harness up inside reel support arm, over
rear pivot pin (Z) and over bolts securing reel
prop and diagonal brace. Continue to lights at
front of reel support arm and make the wire
connections according to the schematic (next
page). Place wires back inside the conduit and
cable tie at (T). Pull excess wiring harness
back through reel support arm. Secure excess
endsheet harness and header harness to
hydraulic line at right endsheet, using small
plastic tie.
S
P
X
Q
Y
Z
INSTALL LIGHTS AT R/H ENDSHEET
N
P
INSTALL LAMP MODULE AT RIGHT ENDSHEET
T
INSTALL LIGHTS AT R/H REEL SUPPORT ARM
D
HARNESS ROUTING - LEFT ENDSHEET
C
J