Header operation operating variables, Shut down procedure – MacDon 963 Harvest Header User Manual

Page 26

Text mode
Original mode

HEADER OPERATION

Operating Variables

DIVIDER ANGLE

The dividers can be angled in or out to provide

proper separation and clean entry in a variety of

crops. Divider gather is factory set at

approximately 1.5 inches (40 mm). In tangled

crops like canola, it may be necessary to reduce

gather.

To adjust angle, loosen hardware (A), position

divider and tighten hardware.

NOTE: On left side, ensure that front hinge pin of

side shield remains covered.

Shut Down Procedure

CAUTION: Before leaving operator's seat for any reason:

1. Park on level ground if possible.
2. Lower the header and reel fully.
3. Place all controls in NEUTRAL or PARK.
4. Disengage header drive.
5. Engage the park brake.
6. Stop engine and remove key from ignition.
7. Wait for all movement to stop.

DIVIDER ANGLE ADJUSTMENT