Brother BES-1261BC - Manual (Page 48)

Chapter 1 Preparation of Embroidery Machine
BES-961BC • BES-1261BC 46
4. Set the needle bar case at the needle bar No. 1. Remove the presser foot
r
from the retracted
machine bed.
Note) • The head of the retracted bed is stopped.
• When removing the presser foot, align the pulley indication mark 3 first.
• To operate the machine in retract position, set the bed in contact with the legs.
Resetting of bed retract
1. Move the machine bed
e
little by little until it comes into contact with the bed support
q
.
2. Loosen two bolts
w
and insert the bed into the right and left directions, then tighten the bolts
securely again.
3. Mount the presser foot for the reset bed
e
.
(Refer to "Chapter 8. Standard Adjustment" for mounting the presser foot.)