Brother BES-1261BC - Manual (Page 47)

Chapter 1 Preparation of Embroidery Machine
BES-961BC
•
BES-1261BC 45
4-5 Bed Retract
When embroidery within the maximum area by mounting the tubular square hoop, there is a
possibility that the hoop interferes with the bed. Retract the bed of several machine heads to
avoid interference. Machine heads with an even number enter a halt status.
Note) The machine heads are numbered 1 ~ 6 from the right side.
No.6
No.4
No.2
e w
q
1. Loosen two bolts
w
that secure the bed support
q
, and move the bolts
w
to the right and
left.
Note) • The bed is secured by two bolts and supported at three places.
• When loosening the bolts, support the bed by hand.
2. Lower the machine bed
e
slowly until it comes into contact with the leg.
3. Tighten the bolts
w
again.
r
This figure shows an example of BES-961BC.
Refer to the same sections for BES-1261BC.